argreen Process Technologies | From Coarse Straining Down to Microfiltration, Reverse Osmosis and Ultra Filtration
Pargreen Process Technologies
1224 Capitol Drive
Addison, IL. 60101
USA

Call: 800.323.2810
Fax: 630.628.3050
Email: sales@pargreen.com
Website: www.pargreen.com
Print Back
The Hypure PF filter is a resin-bonded, spiral wound filter cartridge suitable for a wide range of applications. Hypure PF utilizes phenolic resin impregnated, long-strand polyester fibers for efficiency and long life. Uses for Hypure PF include adhesives, coatings, and inks, and many more applications both water and solvent based.
Unit of Measure

Specifications

Type

 N/A HPF

Nominal Micron Rating

 N/A 3 µm

Length

 N/A 10 in25.4 cm
End #1 Adapter1 N/A Extended Core

End #2 Adapter

 N/A Plain End (No Gasket)
Elastomer Material2 N/A 1

Inside Diameter

 N/A 1 in2.5 cm

Outside Diameter

 N/A 2.5 in6.4 cm

Note

 N/A Trademark of General Electric Company; may be registered in one or more countries.

Features and Benefits

N/A

  • High dirt holding capacity
  • Wide range of micron retention
  • Faster flow rates
  • High efficiency
  • Less change-outs
  • Consistent quality

    • Applications

    N/A

  • Printing inks
  • Water
  • Hot, non-aqueous fluids
  • Adhesives
  • Antifreeze
  • Insecticides
  • Photo resists
  • Solvents
  • Paints and varnishes
  • Thinners
  • Fuels and Lubricating oils
  • Coolants
  • Coatings

    • Materials of Construction

    N/A Phenolic resin impregnated, wound polyester fibers with coreless construction.

    Operational Limits

    N/A Maximum Temperature Rating: 250ºF (121ºC) in gases
    180ºF (82ºC) in aqueous and non-aqueous liquids

    Non Aquenous Liquids

    N/A To size a housing, determine several variables: the desired micron size, the pressure drop permitted, the maximum flow rate and the fluid viscosity. If any three are known, the fourth may be plotted on the nomograph above. Example:

    1. Draw a line from the desired Micron Size (Cartridge Type) through the desired initial Pressure Drop to intersect with Index Line.
    2. Draw a second line from Fluid Viscosity through the Index Line intersection to determine the recommended Flow Rate
    3. Read Flow Rate in GPM. (See Figure 1)
    • 1 End adapters extended core option - polyester extended core 222 O-Ring
    • 2 Viton is a registered trademark of DuPont