argreen Process Technologies | From Coarse Straining Down to Microfiltration, Reverse Osmosis and Ultra Filtration
Pargreen Process Technologies
1224 Capitol Drive
Addison, IL. 60101
USA

Call: 800.323.2810
Fax: 630.628.3050
Email: sales@pargreen.com
Website: www.pargreen.com
Print Back
The A-Series family of proprietary thin-film reverse osmosis membrane elements is characterized by high flux and high sodium chloride rejection. AK HR Low Pressure Brackish Elements are selected when high rejection and low operating pressures are desired. These elements allow significant energy savings since good rejection is achieved at operating pressures as low as 100 psig (689 kPa).

These elements are recommended for low brackish water with salt concentration (TDS) levels up to 1,000mg/l. In turn, AK HR LE elements produce a permeate quality close to a standard brackish membrane element at a much lower pressure.

AK HR LE elements feature a FRP outer wrap and female end connections.
Unit of Measure

Element Specification

Membrane

 N/A Thin-Film Membrane (TFM™)

Average Permeate Flow

 N/A 10200 gpd38.6 m³/day

Average NaCl Rejection

 N/A 99.5 %

Minimum NaCl Rejection

 N/A 99.0 %

Note

 N/A Average salt rejection after 24 hours operation. Individual flow rate may vary +25%/-15%.
Testing conditions: 500ppm NaCl solution at 115psi (862kPa) operating pressure, 77ºF, pH7.5 and 15% recovery.

Active Area

 N/A 400 ft²37.2 m²

Outer Wrap

 N/A Fiberglass

Part Number

 N/A 3040998

Dimensions and Weight

Dimension A (Length)

 N/A 40.0 in101.6 cm
Dimension B1 N/A 1.125 in2.86 cm

Dimension C (Outside Diameter)

 N/A 7.9 in20.1 cm

Boxed Weight

 N/A 35 lb16 kg

Operating and CIP parameters

Typical Operating Pressure

 N/A 120 psi830 kPa

Typical Operating Flux

 N/A 10 - 20 GFD15 - 35 LMH

Maximum Operating Pressure

 N/A 400 psi2758 kPa

Maximum Continuous Operation Temperature

 N/A 122 ºF50 ºC

Maximum Clean-In-Place (CIP) Temperature

 N/A 122 ºF50 ºC

Optimum Rejection pH Range

 N/A 7.0 - 7.5

Continuous Operation pH Range

 N/A 4.0 - 11.0

Clean-In-Place (CIP) pH Range

 N/A 2.0 - 11.5

Maximum Pressure Drop Over an Element

 N/A 12 psi83 kPa

Maximum Pressure Drop Per Housing

 N/A 50 psi345 kPa

Chlorine Tolerance

 N/A 1,000+ ppm-hours, Dechlorination Recommended

Feedwater

 N/A NTU < 1 SDI < 5

Note

N/A These elements are bagged wet (WT) before shipping.
Trademark of General Electric Company; may be registered in one or more countries.

  • 1 Internal diameter unless specified OD (outside diameter).